
MM200 High-Speed Microwave Modem Appendix A
TM086 – Rev. 4.1 A-37
Opcode: <0x2208> Command set common alarm mask
Command Data
<1>
Mask
Common Alarm2
Bit 0 = Glue Logic FPGA Fail
Bit 1 = Test FPGA Fail
Bits 2 – 7 = Spare
0 = Mask, 1 = Allow
Opcode: <0x2209> Command set last rate control
Command Data
1 = Data
Opcode: <0x220A> Command frequency plan
Command Data
Opcode: <0x220B> Command user mode
Command Data
1 = All Access
2 = Level 1
3 = Level 2
Note: Higher user levels restrict access to system control
parameters but allow higher levels of automation
Opcode: <0x220C> Command mux loopback
Command Data
0 = Normal, 1 = Mux/Dmx Loop, 2 = Mux/Dmx LVDS,
3 = Modem LVDS, 4 = Repeater
Note: This command is not valid if the MM200 is in
Opcode: <0x220D> Command repeater mode
Command Data
Opcode: <0x2240> Command modulator frequency
Command Data
Opcode: <0x2241> Command modulator data rate
Command Data
Comentários a estes Manuais