Radyne QAM256 Instruções de Operação Página 33
- Página / 87
- Índice
- MARCADORES
Avaliado. / 5. Com base em avaliações de clientes
QAM256 Digital Video Modulator and Upconverter Rear Panel Interfaces
TM077 – Rev. 4.0 5-1
Rear Panel Interfaces
5
This section discusses the electrical interfaces available from the rear panel. All locations are as
viewed from the rear of the unit unless otherwise specified.
5.0 QAM256 Rear Panel Interfaces/Connections
All QAM256 Interfaces/Connections are made to labeled connectors located on the rear of the
unit. The connector definitions below are those on the QAM256 unit. Any connection interfacing
to the QAM256 must be the appropriate mating connector. Refer to Figure 2-1 for connector
locations. All connectors are as viewed from the rear of the unit unless noted.
Figure 5-1. QAM256 Back Panel
5.1 AC Power
The unit is powered from a 100 – 240 VAC, 50 – 60 Hz source located on the left side of the unit.
Integrated into the power entry module is the Power On/Off Rocker Switch. Power consumption
for the unit is 1A. The power cord/connector assembly is a supplied item. A chassis ground
connection (#10-32 threaded) stud, is located to the lower right of the AC Power Cord
Connection.
5.2 FAULT Connection
The QAM256 has two Form-C dry contact alarm relays onboard and a Fault connector located on
the rear panel. The two relays are designated “1” and “2”. The Modem Alarm B Port (J6) can be
used for modem fault status. The physical interface is a female 9-Pin D-Sub Connector. This
port is an open collector input. The pinouts are listed in Table 5-1.
Table 5-1. FAULT Connection - 9-Pin Female
D-Sub - J6
Pin No. Connection
1 Relay 1 NC
2 Relay 1 C
3 Relay 1 NO (Minor Alarm)
4 Ground
5 NC
6 Mod Fault (Open Collector)
7 Relay 2 NC
- Digital Video Modulator 1
- Warranty Policy 2
- Preface 4
- Table of Contents 6
- TM077 – Rev. 4.0 ix 8
- Introduction 10
- 1-2 TM077 - Rev. 4.0 11
- Installation 12
- 2.2 Removal and Assembly 13
- 2.3 Mounting Considerations 13
- TM077 – Rev. 4.0 2-3 14
- Theory of Operation 15
- 3-2 TM077 - Rev. 4.0 16
- User Interfaces 17
- 4.1.3 Numeric Keypad 18
- 4.2 Parameter Setup 19
- 4.3.1 Main Menus 20
- TM077 – Rev. 4.0 4-5 21
- 4-6 TM077 - Rev. 4.0 22
- TM077 – Rev. 4.0 4-7 23
- 4.5 Connecting the Terminal 24
- 4.6 Terminal Screens 24
- Main Menu Screen: 25
- 4-10 TM077 - Rev. 4.0 26
- TM077 – Rev. 4.0 4-11 27
- 4-12 TM077 - Rev. 4.0 28
- TM077 – Rev. 4.0 4-13 29
- 4-14 TM077 - Rev. 4.0 30
- TM077 – Rev. 4.0 4-15 31
- 4-16 TM077 - Rev. 4.0 32
- Rear Panel Interfaces 33
- 5.3 TX MON Port 34
- 5.4 TX IF Port 34
- TM077 – Rev. 4.0 5-3 35
- 5.5.1 TX PARALLEL Connector 36
- 5.5.2 REMOTE Connector 36
- 5.5.3 TX ASI Connector 36
- 5.8 Optional DVB Interface 37
- 5-6 TM077 - Rev. 4.0 38
- TM077 – Rev. 4.0 5-7 39
- 6.0 Periodic Maintenance 40
- 6-2 TM077 - Rev. 4.0 41
- Technical Specifications 42
- 7.2.1 RF Interface 43
- 7.2.2 Baseband Interface 43
- 7.2.3 Remote Interface 43
- 7.2.4 Physical 43
- TM077 – Rev. 4.0 7-3 44
- Product Options 45
- A-2 TM077 - Rev. 4.0 46
- SNMP MIB 47
- B-2 TM077 – Rev. 4.0 48
- TM077 – Rev. 4.0 B-3 49
- B-4 TM077 – Rev. 4.0 50
- TM077 – Rev. 4.0 B-5 51
- B-6 TM077 – Rev. 4.0 52
- TM077 – Rev. 4.0 B-7 53
- B-8 TM077 – Rev. 4.0 54
- TM077 – Rev. 4.0 B-9 55
- Remote Operations 56
- C.1.2 Protocol Wrapper 57
- TM077 – Rev. 4.0 C-3 58
- 02h = 00000010b 58
- C-4 TM077 – Rev. 4.0 59
- RESPONSE OPCODE DESCRIPTION 59
- Invalid Control Mode 59
- C.1.5 Collision Avoidance 60
- C.1.6 Software Compatibility 61
- C.1.8 RLLP Summary 62
- C-8 TM077 – Rev. 4.0 63
- TM077 – Rev. 4.0 C-9 64
- C-10 TM077 – Rev. 4.0 65
- TM077 – Rev. 4.0 C-11 66
- C-12 TM077 – Rev. 4.0 67
- TM077 – Rev. 4.0 C-13 68
- C-14 TM077 – Rev. 4.0 69
- TM077 – Rev. 4.0 C-15 70
- C-16 TM077 – Rev. 4.0 71
- TM077 – Rev. 4.0 C-17 72
- C-18 TM077 – Rev. 4.0 73
- TM077 – Rev. 4.0 C-19 74
- C-20 TM077 – Rev. 4.0 75
- TM077 – Rev. 4.0 C-21 76
- C-22 TM077 – Rev. 4.0 77
- TM077 – Rev. 4.0 C-23 78
- C-24 TM077 – Rev. 4.0 79
- TM077 – Rev. 4.0 C-25 80
- C-26 TM077 – Rev. 4.0 81
- Glossary 82
- G-2 TM077 – Rev. 4.0 83
- TM077 – Rev. 4.0 84
- G-4 TM077 – Rev. 4.0 85
- G-6 TM077 – Rev. 4.0 87
Manuais e produtos relacionados com Modulador Radyne QAM256
Modulador Radyne DMDVB20 LBST Instruções de Operação
(113 páginas)
(113 páginas)
Modulador Radyne DM240XR Especificações
(196 páginas)
(196 páginas)
© 2020, manymanuals-pt.com. Todos os direitos reservados. | 0.240 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentários a estes Manuais